How To Remove Your Flutter Lashes

Gentle & Effective: Your Flutter Lash Removal Guide

Ready for a fresh lash look or perhaps it's time for your weekly Lash Reset? Removing your Flutter lashes is designed to be a gentle experience and our effective Remover is specifically designed for safe at-home removal. You'll find absolutely no tugging or pulling here – at Flutter, we’re all about protecting your natural lash health every step of the way. Follow these simple steps for a smooth transition.

Step-by-Step Removal

1. Apply Remover
   Generously brush Remover directly onto the bonded areas of your lash clusters, both from the top and underneath if possible.
2. Let it Work its Magic
   Allow the Remover to sit and soak into the bond until it begins to loosen. This might take a few minutes. If necessary, you can apply a little more Remover. Patience is key!
3. Gently Slide & Remove
   Once the bond has softened, the lash clusters should gently slide off your natural lashes. You can use your remover wand, a clean spoolie, or gently wipe downwards with a lint-free pad to help guide them off.
   • Critical: Never, ever pull, tug, or pick at your extensions or natural lashes! This can cause damage and can lead to lash loss. Always wait for the Remover to do its job and break down the bond completely.

Post-Removal Care

• Cleanse & Refresh Your Natural Lashes
  

  Once all your clusters are removed, ensure any lingering Bond and Seal residue is gone. You can do this by gently going over the areas again with a little more of our Remover (letting it sit for a moment to dissolve any stubborn spots), followed by thoroughly cleansing your natural lashes and eyelids with an oil-based cleanser (like a waterproof makeup remover). This will remove any final traces and leave your lashes feeling fresh.

Important Note for Immediate Reapplication

Planning to apply a fresh set of lashes right away? For your new Bond to adhere perfectly and to ensure long-lasting wear, all traces of the Remover or oil-based cleanser must be completely gone. After completing the 'Cleanse & Refresh' step above:

• Thoroughly re-cleanse your natural lashes and entire eye area two to three times using your dedicated oil-free lash cleanser (the same one you use for daily lash hygiene or initial pre-application prep).
• Pat gently and ensure your lashes are completely clean and dry before starting your new Bond application. This creates the perfect oil-free canvas for your next flawless Flutter look!